ProductsCurrent position: Home > > Products
Spot hot melt glue machine heating glue machine Add time：2020-08-16
Product details
Test run preparation
1. Eliminate rust proof grease.
2. Inject enough lubricating oil into each lubricating point (oil cup, oil hole and gear).
3. Manually check whether there are various tools or hard objects forgotten on the drum, and use the roller to rotate flexibly
To avoid damage to drum and other machine accessories when starting.
4. The machine must be placed on the horizontal working surface, and there must be no serious inclination, otherwise, the glue liquid will turn to
One end gathers and flows out of the rubber plate.
5. Turn on the power supply when there is no abnormality.
Adjustment and operation
1. Adjustment of the thickness of the upper rubber layer
At the same time, rotate the adjustment handle (one on the left and one on the left) to make the rubber roller move forward and backward. Between it and the upper cot
The thickness of the adhesive layer can be adjusted in the range of 0.03-0.05mm.
2. Adjustment of press roll
At the same time, rotate the paper roller adjusting handle (one on the left and one on the left) to make the paper roller move up and down
And out of the paper gap.
3. Disassembly and assembly of Cots
At the same time, rotate the thickness of the upper rubber surface, adjust the handle to a certain depth, lift the working table plate, and take out the rubber roller
Installation.
4. Disassembly and assembly of rubber disc
The rubber disc mechanism of this machine is parallelogram, and the rubber can be taken out by pulling the loading and unloading handle of the rubber plate anticlockwise
On the contrary, the rubber plate can be installed.
Maintenance
1. When starting the machine, turn on the governor switch and slowly rotate the speed control knob until you notice the speed. Shutdown
Return the speed control knob to zero first. Then turn off the governor switch. Be careful not to turn off the governor switch directly.
Avoid damaging the governor.
2. When the rubber tray bracket is reset, press and hold the handle of the glue tray to let it reset slowly.
3. 30% lubricating oil must be added to each relative moving point regularly, 3-5 times a day, to maintain the teeth of each drum
The lubrication of the wheel can prolong the service life of the machine tool.
4. When cleaning the drum, the machine should be stopped to clean all residual glue, so as to avoid the cleaning cloth turning into the roller
Cylinder, affecting the normal operation of the drum.
5. Hard objects and other tools are not allowed to be placed on the workbench.
6. In case of failure during operation, the power supply shall be cut off immediately.
Contact person: Ms. Li
Hand machine: 13587588683
Mail box:sxmachines@126.com
